What are the factors that cause excessive burrs when cutting with high speed metal circular saw machine.
High-speed metal circular saw machine is a metal cutting processing equipment, cut off the surface of the material is smooth, no burrs, but sometimes there are too many burrs on the workpiece or the cutting surface is not smooth, what is the cause?
First, saw blade maintenance of circular saw machine.
Cause analysis: The circular saw blade itself is sure to be used for a long time, more than the time will be grinding, if not grinding, it will produce instability when cutting off and the workpiece surface burr too much or parallelism deterioration, serious will also produce tooth explosion and other serious accidents.
Solution: Timely maintenance and grinding of the blade of the high-speed metal circular saw machine, do not wait for the saw blade to be necessary to repair and replace it, should be prepared in advance.
Cause analysis: When replacing the circular saw blade, the saw blade was not carefully checked, such as cracks in the blade, gaps in the serrated tooth, teeth loss and other problems.
Solution: Before using the circular saw blade, if the saw blade is damaged, it is not recommended to install it again.
Third, check the magnetic powder clutch.
Reason analysis: The magnetic powder clutch of high-speed metal circular saw machine is to protect and stabilize the circular saw blade, so that the cutting is more accurate and more efficient; If the magnetic powder clutch has a problem, it will lead to unstable operation of the circular saw blade, causing problems caused by various cuts.
Solution: Stop the device and conduct a series of checks according to the actual situation and instructions. It is recommended that professional maintenance and repair personnel troubleshoot the accident.
